Kia Forte: Heated Oxygen Sensor (HO2S) Specification
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Specification
HO2S [Bank 1/Sensor 1] (Linear type)
| Item |
Specification |
| Heater Resistance (Ω) |
2.4 ~ 4.0 [20°C(68°F)] |
HO2S [Bank 1/Sensor 2] (Binary type)
| A/F Ratio (λ) |
Output Voltage(V) |
| RICH |
0.6 ~ 1.0 |
| LEAN |
0 ~ 0.4 |
| Item |
Specification |
| Heater Resistance (Ω) |
Approx. 9.0 [20°C(68°F)] |
Heated Oxygen Sensor (HO2S) Description
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed
both upstream and downstream of the Catalytic Converter. It varies in accordance
with the air/fuel ratio.
Th ...
Heated Oxygen Sensor (HO2S) Circuit Diagram
(M/T)
(A/T)
...
See also:
Radiator Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine coolant, and
then install it on a pressure tester.
2.
...
Mode Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode con ...
Muffler Removal and Installation
Front Muffler
1.
Detach the rubber hanger (A) from the front muffler.
2.
Remove the front muffler (B).
Tightening ...
Copyright © www.kifomanual.com 2014-2024