1. |
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat switch.
A : Power seat control switch
B : Lumbar support switch
|
Inspection
1.
Check the bushing for wear.
2.
Check the brake pedal for bending or twisting.
3.
Check the brake pedal retur ...
Installation
Clutch cover and disc should be replaced as a set.
1.
Apply grease on a disc spline ...
Installation
Pressure Side Impact Sensor
1.
Install the new pressure side impact sensor with the screws (B)
then connect the pressure side impact sensor connector (A).
...