1. |
Install in the reverse order of removal.
|
2. |
After be equipped, perform bleeding air procedure in clutch release
cylinder after pouring the brake fluid.
(Refer to Clutch System - "Clutch release cylinder")
|
Front Cross Member
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
...
Rear Pillar Trim Replacement
(4Door)
•
Put on gloves to protect your hands.
...
Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground
the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace
it.
Horn Relay Inspec ...