1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the IATS connector.
|
3. |
Measure resistance between the IATS terminals 3 and 4.
|
4. |
Check that the resistance is within the specification.
|
Inhibitor Switch Specifications
▷ Type: Combination of output signals from 4 terminals
Power supply (V)
12
Output type
Combination of output signals
Signal Code Table
...
Troubleshooting
Symptom
Possible cause
Remedy
Tachometer does not operate
Cluster fuse (10A) blown
Check for short and replace fuse
CAN line faulty
...
Engine start/stop button
Illuminated ENGINE START/STOP button
Whenever the front door is opened, the ENGINE START/STOP button will illuminate
for your convenience.
The light will go off after about 30 seconds after the ...