Kia Forte: 26 Brake Control Solenoid Valve(26/B_VFS) Inspection - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: 26 Brake Control Solenoid Valve(26/B_VFS) Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Inspection

1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
(Refer to 26 Brake Control Solenoid Valve - "Specifications")
26 Brake Control Solenoid Valve(26/B_VFS) Circuit Diagram
...

26 Brake Control Solenoid Valve(26/B_VFS) Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

See also:

ISG OFF Switch Inspection
1. Remove the crash pad side switch assembly (A) from the switch panel on the crach pad of the driver's side. 2. Remove the ISG ...

Engine Control Module (ECM) Removal
   When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. ...

Crankshaft Disassembly
   • Use fender covers to avoid damaging painted surfaces. • ...

Copyright © www.kifomanual.com 2014-2025