1. |
After loosening the hinge (A) mounting bolt, adjust the hood (B)
by moving it up or down, or right or left.
|
2. |
Adjust the hood height by turning the hood overslam bumpers (C).
|
3. |
After loosening the hood latch (D) mounting bolts, adjust the
latch by moving it up or down, or right or left.
|
Side Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front side m ...
Ambient Temperature Sensor Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect ambient temperature sensor.
3.
Check the resistance of the ambie ...
Components
(4Door, 5Door)
1. Front pillar trim
2. Center pillar lower trim
3. Center pillar upper trim
4. Rear pillar trim
5. Rear wheel house trim
6. Cowl side trim
...