Kia Forte: Alternator Disassembly
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Charging System / Alternator Disassembly
| 1. |
Remove the rear cover (A) after removing nuts (B).
|
| 2. |
Remove the mounting bolts (A) and the regulator assembly (B).
|
| 3. |
Remove the slip ring guide (A) after pulling it.
|
| 4. |
Remove the OAD(Overrunning Alternator Decoupler) cap.
|
| 5. |
Remove the OAD(Overrunning Alternator Decoupler) pulley (A) using
the special tool.
|
| 6. |
Unsolder the 3 stator leads (A).
|
| 7. |
Remove the 4 through bolts (A).
|
| 8. |
Disconnect the rotor (A) and housing (B).
|
Alternator Installation
1.
Install in the reverse order of removal.
2.
Adjust the alternator belt tension after installation.
(Refer to Engine Mechanical ...
Alternator Reassembly
1.
Reassemble in the reverse order of disassembly.
•
...
See also:
DC/DC Converter Removal
1.
Disconnect the battery negative (-) cable.
2.
Remove the crash pad lower panel.
(Refer to Body - Crash pad lower panel.)
...
Inhibitor Switch Description
Inhibitor Switch monitors the lever's position(P, R, N, D) and is used
to control gear setting signals.
...
Tightening Torque
Part tightened
N.m
Kgf.m
lbf.ft
Condenser - Discharge hose
7.8~11.7
0.8~1.2
5.7~8.6
Condenser - Liquid tube
Comp ...
Copyright © www.kifomanual.com 2014-2025