Kia Forte: Battery Description - Charging System - Engine Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Battery Description

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Charging System / Battery Description

1.
The CMF(Closed Maintenance Free) battery is, as the name implies, totally maintenance free and has no removable battery cell caps.
2.
The MF(Closed Maintenance Free) battery does not require water replenishment for the repair.
3.
The battery is completely sealed, except for small vent holes in the cover.

  
After disconnecting then reconnecting the battery negative cable, reset some parts that require the reset procedures. (Refer to Body Electrical System – "General Information")
[AGM Battery for ISG System]
AGM battery is used for especially heavy load on the vehicle network depending on equipment and requirements. AGM stands for Absorbent Glass Material Battery; that is absorbent glass fibre fleece. AGM batteries are fitted in models with electrical loads/consumers which have a high energy demand.
The constantly increasing energy demand of modern vehicle electrical systems calls for ever more powerful battery solutions.
The power consumption is considerable even when the vehicle is parked.
The somewhat higher price compared with a battery of similar size is fully balanced by the following benefits:
-
Significantly longer service life
-
Increased starting reliability at low temperatures
-
100 % freedom from maintenance
-
Low risk in event of an accident (reduced risk to the environment)

DC/DC Converter Installation
1. Install in the reverse order of removal.    If the battery negative (-) c ...

Battery Specifications
Battery [Non-ISG type] Item Specification Model type CMF60L-DIN Capacity [20HR / 5HR] (AH) 60 / 48 Cold Cranking Amperage (A) ...

See also:

Intake Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuato ...

Knock Sensor (KS) Description
Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. Whe ...

Power Door Lock Switch Inspection
Driver Door Lock Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front ...

Copyright © www.kifomanual.com 2014-2025