Kia Forte: Battery saver function - Lighting - Features of your vehicle - Kia Forte TD 2014-2018 Owners ManualKia Forte: Battery saver function

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Owners Manual / Features of your vehicle / Lighting / Battery saver function

If necessary, to keep the lights on when the ignition key is removed, perform the following:

1) Open the driver-side door.

2) Turn the parking lights OFF and ON again using the light switch on the steering column.

Headlight escort function (if equipped)

The headlights (and/or taillights) will remain on for approximately 20 minutes after the ignition key is removed or turned to the ACC or LOCK position.

However, if the driver’s door is opened and closed, the headlights are turned off after 30 seconds.

The headlights can be turned off by pressing the lock button on the transmitter (or smart key) twice or turning off the light switch from the headlight or Auto light position.

CAUTION

If the driver gets out of the vehicle through other doors (except driver's door), the battery saver function does not operate and the headlight escort function does not turn off automatically. Therefore, It causes the battery to be discharged. In this case, make sure to turn off the lamp before getting out of the vehicle.

WARNING

If the headlights are not working properly have your vehicle inspected by an authorized Kia dealer. Don't attempt to inspect or replace the wiring yourself to prevent malfunction.

Lighting
...

Daytime running light 
Daytime Running Lights (DRL) can make it easier for others to see the front of your vehicle during the day. DRL can be helpful in many different driving conditions, and it is especially helpful aft ...

See also:

Cluster Ionizer Description
The cluster ionizer helps clean odor in the vehicle or from the air-conditioner system. When the ignition switch is ON, the inoizer runs a "CLEAN" mode and then a "ION" ...

Cylinder Head Cover Installation
1. Install cylinder head cover. (1) The hardening sealant located on the cylinder head cover and the gap between the timing chain co ...

Checking the engine oil level
1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...

Copyright © www.kifomanual.com 2014-2026