Kia Forte: Brake Booster Vacuum Pressure Sensor Installation - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Brake Booster Vacuum Pressure Sensor Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Brake Booster Vacuum Pressure Sensor Installation

  
Brake Booster Vacuum Pressure Sensor can not be replaced separately due to vacuum leak.
Therefore, the sensor must be replaced with an assembly with the brake booster.
(Refer to Brake System - Brake Booster)
Brake Booster Vacuum Pressure Sensor Removal
   Brake Booster Vacuum Pressure Sensor can not be replaced separately due to vacuum leak. Therefore, the sensor mu ...

AGM Battery Description
AGM battery is used for especially heavy load on the vehicle network depending on equipment and requirements. AGM stands for Absorbent Glass Material Battery; that is absorbent glass fibre fl ...

See also:

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...

Output Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Battery replacement
A battery should last for several years, but if the transmitter or smart key is not working properly, try replacing the battery with a new one. If you are unsure how to use or replace the batter ...

Copyright © www.kifomanual.com 2014-2024