Kia Forte: Checking the brake/clutch  fluid level - Brake fluid - Maintenance - Kia Forte TD 2014-2018 Owners ManualKia Forte: Checking the brake/clutch  fluid level

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Owners Manual / Maintenance / Brake fluid / Checking the brake/clutch  fluid level

Check the fluid level in the reservoir periodically. The fluid level should be


Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir.

Before removing the reservoir cap and adding brake/clutch* fluid, clean the area around the reservoir cap thoroughly to prevent brake/clutch fluid contamination.

CAUTION - Proper fluid

Only use brake/clutch fluid in brake/clutch system. Small amounts of improper fluids (such as engine oil) can cause damage to the brake/clutch system.

If the level is low, add fluid to the MAX level. The level will fall with accumulated mileage. This is a normal condition associated with the wear of the brake linings and/or clutch disc (if equipped). If the fluid level is excessively low, have the brake/clutch* system checked by an authorized Kia dealer.

In the event the brake/clutch system requires frequent additions of fluid, the vehicle should be inspected by an authorized Kia dealer.

When changing and adding brake/clutch* fluid, handle it carefully.

Do not let it come in contact with your eyes. If brake/clutch  fluid should come in contact with your eyes, immediately flush them with a large quantity of fresh tap water. Have your eyes examined by a doctor as soon as possible.

CAUTION - Brake/clutch fluid

Do not allow brake/clutch  fluid to contact the vehicle's body paint, as paint damage will result.

Brake/clutch fluid, which has been exposed to open air for an extended time should never be used as its quality cannot be guaranteed. It should be disposed of properly.

Brake fluid
...

Washer fluid
...

See also:

Special Service Tools
Tool Name / Number Illustration Description Alternator pulley remover wrench 09373-27000 Removal and installation of alternator pulley ...

Rear Door Side Weatherstrip Replacement
(4Door, 5Door) 1. Loosen the rear door checker (B) mounting bolt. Tightening torque: 16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m,12.3 ~ ...

Cylinder Head Removal
Engine removal is not required for this procedure.    • Use fender covers to avoid damaging pa ...

Copyright © www.kifomanual.com 2014-2024