Kia Forte: DC/DC Converter Installation
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / DC/DC Converter Installation
| 1. |
Install in the reverse order of removal.
|
DC/DC Converter Removal
1.
Disconnect the battery negative (-) cable.
2.
Remove the crash pad lower panel.
(Refer to Body - Crash pad lower panel.)
...
ISG OFF Switch Description
The ISG OFF switch on the crash pad lower panel can be used to deactivate
the ISG function. ...
See also:
Crankshaft Position Sensor (CKPS) Specification
Item
Specification
Coil Resistance(Ω)
774 ~ 946 [20°C (68°F)]
...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
Rear Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Side outer p ...
Copyright © www.kifomanual.com 2014-2025