Kia Forte: Defroster - Features of your vehicle - Kia Forte TD 2014-2018 Owners ManualKia Forte: Defroster

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Owners Manual / Features of your vehicle / Defroster

CAUTION - Conductors

To prevent damage to the conductors bonded to the inside surface of the rear window, never use sharp instruments or window cleaners containing abrasives to clean the window.

If you want to defrost and defog the front windshield, refer to "Windshield Defrosting and Defogging" in this section.

Rear window defroster

The defroster heats the window to remove frost, fog and thin ice from the interior


The defroster heats the window to remove frost, fog and thin ice from the interior and exterior of the rear window, while the engine is running.

To activate the rear window defroster, press the rear window defroster button located in the center facia switch panel. The indicator on the rear window defroster button illuminates when the defroster is on.

If there is heavy accumulation of snow on the rear window, brush it off before operating the rear defroster.

The rear window defroster automatically turns off after approximately 20 minutes or when the ignition switch is turned off. To turn off the defroster manually, press the rear window defroster button again.

Outside mirror defroster (if equipped)

If your vehicle is equipped with the outside rearview mirror defrosters, they will operate at the same time you turn on the rear window defroster.

Front wiper deicer (if equipped)

If your vehicle is equipped with the front wiper deicer, it will be operating at the same time you operate the front windshield defroster.

Headlamp welcome
When the headlight(light switch in the headlight or AUTO position) is on and all doors (and trunk/tailgate) are locked and closed, the headlight, position light and tail light will come on for 1 ...

Climate control system
є 1. Fan speed control knob 2. Mode selection knob 3. Temperature control knob 4. Air conditioning button 5. Air intake control button 6. Rear window defroster button Heating and air conditio ...

See also:

Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning directio ...

Output Speed Sensor Description
The output speed sensor is a vital unit that measures the rate of rotation of the transaxle's turbine shaft and output shaft, and delivers the readings to the Transaxle Control Module(TCM ...

TJ Joint Replacement
   • Special grease must be applied to the driveshaft joint. Do not substitute with another ...

Copyright © www.kifomanual.com 2014-2024