Kia Forte: Description

Ignition timing is controlled by the electronic control ignition timing system.

The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module).

The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM.

The ignition coil is activated, and timing is controlled.

Ignition System

...

On-vehicle Inspection

Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.    ...

See also:

Rear Drum Brake
Components 1. Shoe hold down pin 2. Shoe adjuster 3. Upper return spring 4. Adjusting lever 5. Shoe 6. Adjusting spring 7. Lower return spring 8. Shoe hold spri ...

Front Wiper Motor Installation
1. Install the wiper motor. 2. Install the crank arm.    ...

Removal
1. Disconnect the brake fiuid level switch connector, and remove the reservoir cap. 2. Remove the brake fluid from the master cylinder rese ...