1. |
Check the engine oil quality.
Check the oil deterioration, entry of water, discoloring of thinning.
If the quality is visibly poor, replace the oil.
|
2. |
Check the engine oil level.
After engine warm up stop the engine wait 5 minutes then check
the oil level. Oil level should be between the "L" and "F" marks on
the dipstick. If low check for leakage and add oil up to the "F" mark.
|
For best performance and maximum protection of all types of operation,
select only those lubricants which:
|
Windshield washers (front)
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wip ...
Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents
are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower
of driv ...
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the smart junction box
(Refer to Body Electri ...