Kia Forte: Filler-Neck Assembly Installation - Fuel Delivery System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Filler-Neck Assembly Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly Installation

1.
Install in the reverse order of removal.

Filler-neck assembly bracket installation bolt :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Filler-Neck Assembly Removal
1. Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A). 2. Remove the rear-LH wheel, tire, and the i ...

Accelerator Pedal Removal
1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). ...

See also:

Relay Box (Passenger Compartment) Removal
Passenger Compartment Junction Box (SJB) 1. Disconnect the negative(-) battery terminal. 2. Remove the crash pad lower panel. (Refer ...

Seat Heater (Air Ventilation) Component Location
...

Compressor Installation
1. Make sure the compressor mounting bolt with the correct length is screwed in. Tighten the mounting bolts (A) with the specified tightening order. ...

Copyright © www.kifomanual.com 2014-2025