Kia Optima Manuals

Kia Forte: Inspection - Brake Pedal - Brake System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Brake System / Brake Pedal / Inspection

1.
Check the bushing for wear.
2.
Check the brake pedal for bending or twisting.
3.
Check the brake pedal return spring for damage.
4.
Check the stop lamp switch.
(1)
Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in and when it is released.
(2)
The stop lamp switch is in good condition if there is no continuity when plunger(A) is pushed.
Removal
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to Body - & ...

Installation
1. Pre-tighten the bracket fixing bolt (A) in dash panel. 2. Install the brake booster and brake pedal member fixing nuts (A) secur ...

See also:

Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

Important Safety Notice
Proper service methods and repair procedures are essential for safe, reliable operation of all motor vehicles as well as personal safety of the operator. The service procedures and descriptio ...

Components
Components (1) (4Door) 1. Front bumper cover 2. Front bumper upper weatherstrip 3. Front bumper side bracket [LH] 4. Front bumper side bracket [RH] Co ...

Categories


Copyright © www.kifomanual.com 2014-2025