Kia Forte: Under Body
| Projected Dimensions |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Actual-Measurement Dimensions |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Front side member tooling hole (Ø25) |
Side cover mounting hole (Ø8.6) |
Side cover mounting hole (Ø10.7) |
|
|
|
|
| Sub frame mounting bolt |
Sub frame mounting hole (Ø11) |
Center floor tooling hole (Ø8) |
|
|
|
|
| Front side member tooling hole (Ø13) |
Center floor side member tooling hole
(Ø7) |
Rear floor side member tooling hole (Ø10) |
|
|
|
|
| Rear floor side member tooling hole (Ø10) |
Rear floor side member tooling hole (Ø10) |
Rear floor center cross member tooling hole (Ø10) |
|
|
|
|
| Rear floor center cross member tooling hole (Ø10) |
Rear spring mounting hole (Ø9) |
Rear floor side member tooling hole (Ø8) |
|
|
||
| Rear floor side member tooling hole (Ø8) |
Rear Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Side outer p ...
Front Cross Member
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
...
See also:
Compressor Installation
1.
Make sure the compressor mounting bolt with the correct length
is screwed in. Tighten the mounting bolts (A) with the specified tightening
order.
...
Opening the fuel filler lid
The fuel filler lid must be opened from inside the vehicle by pulling up the
fuel filler lid opener.
If the fuel filler lid does not open because ice has formed around it, tap lightly
or push o ...
On-board Refueling Vapor Recovery (ORVR) valve Installation
1.
Installation is the reverse of removal.
...
Copyright © www.kifomanual.com 2014-2024