Kia Forte: Hood Latch Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Replacement

1.	Disconnect the hood latch connector (A).

2.

Remove the hood latch assembly (A) mounting bolts.

Tightening torque :

7.8 ~ 11.8N.m (0.8 ~ 1.2kgf.m, 5.8 ~ 8.7 lb-ft)

3.	Disconnect the hood latch release handle cable (B) and remove the hood latch assembly (A).

4.

Install in the reverse order of removal.

•	Make sure the hood latch release cable is connected properly.

•	Make sure the hood locks/unlocks and opens/closes properly.

•	Adjust the latch alignment.

Hood Latch Component Location

1. Hood latch assembly ...

Trunk Lid

...

See also:

On-board Refueling Vapor Recovery (ORVR) valve Installation
1. Installation is the reverse of removal. ...

Receiver-Drier Replacement
1. Remove the condenser, and then remove the bottom cap (B) with a L wrench (A) from the condenser. Tightening torque : 9.8~14.7N.m ( ...

Alternator Installation
1. Install in the reverse order of removal. 2. Adjust the alternator belt tension after installation. (Refer to Engine Mechanical ...

Categories

Copyright © www.kifomanual.com 2014-2025