Kia Forte: Trunk Lid Assembly Replacement
| •
|
Wear gloves to protect hands from injury.
|
|
| •
|
When removing and installing the trunk lid, an assistant
is necessary.
|
|
|
1. |
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
|
|
2. |
Disconnect the connectors and trunk lid wiring harness (A).
|
|
3. |
After loosening the mounting bolts, then remove the trunk lid
assembly (B).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
|
4. |
Install in the reverse order of removal.
|
• |
Make sure the trunk lid locks/unlocks and opens/closes
properly.
|
|
• |
Adjust the trunk lid alignment.
|
|
• |
Make sure the connectors are connected in properly.
|
|
• |
Replace any damaged clips.
|
|
|
(4Door, 2Door)
1. Trunk lid assembly
...
(4Door, 2Door)
1. Trunk lid trim
...
See also:
Component Location
[Engine Room]
1. Receiver Drier
2. Condenser
3. Ambient Temperature Sensor
4. Compressor
5. Discharge Hose
6. Suction & Liquid Tube Assembly
7. Servic ...
ETC (Electronic Throttle Control) System Specification
Throttle angle (°)
Output voltage (V) [Vref = 5.0V]
TPS1
TPS2
0
0.5
4.5
10
0.96
4.05
20
1.41 ...
Weight Classification System (WCS)
WCS is intended to detect the occupant’s physique in order to determine
whether the passenger airbag should be suppressed or deployed. WCS classifies
the front passenger side seat by measurin ...
Trunk Lid Assembly Component Location
Trunk Lid Trim Component Location