Kia Forte: Front Seat Shield Outer Cover Replacement
•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Loosen the front seat shield outer cover mounting screws.
|
2. |
To remove the front seat shield outer cover (A), push the lock
pin (B) in the direction of the arrow.
|
3. |
Disconnect the connector (A).
|
4. |
Install in the reverse order of removal.
• |
Make sure the connector is plugged in properly.
|
• |
Replace any damaged clips.
|
|
|
(2Door)
•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the height adjust lever cap (A).
|
2. |
After loosening the mounting screws, then remove the height adjust
lever (B).
|
3. |
To, disengage the lock pin, pull the recliner lever (A) after
pushing lock pin hole (B) with the pointed instrument (C).
• |
Be careful not to damage the lock pin.
|
|
|
4. |
Loosen the front seat shield outer cover mounting screws.
|
5. |
To remove the front seat shield outer cover (A), push the lock
pin (B) in the direction of the arrow.
|
6. |
Disconnect the connector (A).
|
7. |
Install in the reverse order of removal.
• |
Make sure the connector is plugged in properly.
|
• |
Replace any damaged clips.
|
|
|
1. Front seat shield outer cover
...
1. Front seat shield inner cover
...
See also:
Seat Heater Switch Installation
Driver/Passenger Seat
1.
Install the switchs and connect the switch connectors.
2.
Insatll the floor console assembly.
...
Specifications
Items
Specifications
Rated voltage
DC 12V
Operating voltage
DC 9 ~ 16V
Operating temperature
-22°F~176°F(-30°C~ 80°C)
...
Hazard Lamp Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel.
(Refer to Body - "Center Fascia Panel")
...