Kia Forte: Front Washer Motor Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Windshield Wiper/Washer / Front Washer Motor Removal

-	When servicing the washer pump, be careful not to damage the washer pump seal.

-	Do not operate the washer pump before filling the washer reservoir. Failure to do so could result in premature pump failure.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front bumper cover. (Refer to Body - "Front Bumper Cover")

3.	Remove the washer hose and disconnect the washer motor connector (A).

4.	Remove the washer reservoir after loosening bolts and screw.

Front Washer Motor Inspection

1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. ...

Front Washer Motor Installation

1. Install the washer reservoir. Before installing the pump motor, check ...

See also:

Hood switch Description
The hood switch is included as the influencing factors in the calculation of the ISG function. If the hood is open, the engine must not be started or stopped by the ISG function for safety re ...

Transaxle Oil Temperature Sensor Inspection
1. Turn ignition switch OFF. 2. Disconnect the Solenoid valve connector. 3. Measure resistance between sensor ...

Cruise control system
The cruise control system allows you to program the vehicle to maintain a constant speed without depressing the accelerator pedal. This system is designed to function above approximately 25 mph (40 ...

Categories

Copyright © www.kifomanual.com 2014-2024