Kia Forte: Limp Home Function - Immobilizer System - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Limp Home Function

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Immobilizer System / Limp Home Function

1.
Limp Home By Tester
If the ECM detects the fault of the Immobilizer or transponder, the ECM will allow limp home function of the immobilizer. Limp home is only possible if the user password (4 digits) has been given to the ECM before. This password can be selected by the vehicle owner and is programmed at the service station.
The user password can be sent to the ECM via the special tester menu.
Only if the ECM is in status "learnt" and the user password status is "learnt" and the user password is correct, the ECM will be unlocked for a period of time (30 sec.). The engine can only be started during this time. After the time has elapsed, engine start is not possible.
If the wrong user password is sent, the ECM will reject the request of limp home for one hour. Disconnecting the battery or any other action cannot reduce this time. After connecting the battery to the ECM, the timer starts again for one hour.

2.
Limp Home By Ignition Key
The limp home can be activated also by the ignition key. The user password can be input to the ECM by a special sequence of ignition on/off.
Only if the ECM is in status "learnt" and the user password status is "learnt" and the user password is correct, the ECM will be unlocked for a period of time (30 sec.).
The engine can be started during this time. After the time has elapsed, engine start is not possible. After a new password has been input, the timer (30 sec.) will start again.
After ignition off, the ECM is locked if the timer has elapsed 8 seconds. For the next start, the input of the user password is requested again.

Teaching Procedures
1. Key Teaching Procedure Key teaching must be done after replacing a defective ECM or when providing additional keys to the vehicle owner. The procedure st ...

Replacement
Problems And Replacement Parts: Problem Part set Scan tool required? All keys have been lost Blank key (4) YES Antenna coil unit does n ...

See also:

Output Speed Sensor Description
The output speed sensor is a vital unit that measures the rate of rotation of the transaxle's turbine shaft and output shaft, and delivers the readings to the Transaxle Control Module(TCM ...

Specifications
Transaxle type M6CF3-1 Engine type Gasoline 1.8 MPI / Gasoline 2.0 GDI 4/5DR 2DR Gear ratio 1st 3.308 3.615 ...

Cooling Fan Description
[Air conditioning type] The cooling fan operates in 2 stages (HIGH/LOW). The engine control module (ECM) controls the cooling fan according to the coolant temperature, vehicle speed and A ...

Copyright © www.kifomanual.com 2014-2024