1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
|
3. |
Disconnect the connector (B) after loosening the screw and then
remove the antenna coil (A).
|
Under Body
Projected Dimensions
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Actual-Measurement Dimensions
...
System operation
Ventilation
1. Set the mode to the
position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed ...
Oil Cooler Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine coolant, and
then install it on a pressure tester.
2.
...