1. |
Check the condenser fins for clogging and damage. If clogged,
clean them with water, and blow them with compressed air. If bent, gently
bend them using a screwdriver or pliers.
|
2. |
Check the condenser connections for leakage, and repair or replace
it, if required.
|
Crankshaft Position Sensor (CKPS) Inspection
1.
Check signal waveform of CKPS and CMPS using a scan tool.
Specification:
Refer to “Waveform”
...
Accelerator Pedal Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the accelerator position sensor connector (A). ...
Manual transaxle operation
The manual transaxle has 6 forward gears.
This shift pattern is imprinted on the shift knob. The transaxle is fully synchronized
in all forward gears so shifting to either a higher or a lower ge ...