[1st Method] |
1. |
Start the engine and keep the engine running at idle for 2 minutes.
|
2. |
Step on the accelerator pedal and hold it steady at 4500 rpm with
the shift lever in N position to warm up the engine until the
temperature of the engine coolant reaches 80°C.
|
3. |
Keep the engine running at 2500~3000 rpm in the N position for
15 minutes.
|
[2nd Method] |
|
1. |
Start the engine and keep the engine running at idle for 2 minutes.
|
2. |
Drive the vehicle for over 20 minutes, keeping the engine speed
above 3500 rpm.
|
Installation
•
Install the concentric slave cylinder bolts. Not to be
bent or twisted, Tighten them i ...
Inhibitor Switch Description
Inhibitor Switch monitors the lever's position(P, R, N, D) and is used
to control gear setting signals.
...
Crankshaft Damper Pulley Removal and Installation
1.
Remove the RH front wheel.
2.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
3.
...