[Rotor] |
1. |
Check that there is continuity between the slip rings (C).
|
2. |
Check that there is no continuity between the slip rings and the
rotor (B) or rotor shaft (A).
|
3. |
If the rotor fails either continuity check, replace the alternator.
|
[Stator] |
1. |
Check that there is continuity between each pair of leads (A).
|
2. |
Check that there is no continuity between each lead and the coil
core.
|
3. |
If the coil fails either continuity check, replace the alternator.
|
Intake Air Temperature Sensor (IATS) Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS termi ...
Hood Insulator Pad Replacement
1.
Using a clip remover, detach the clips, and remove the hood insulator
pad (A).
...
Telemetics Unit (TMU) Installation
1.
Install the MTS unit after connecting the cable and connector.
2.
Install the glove box housing.
3.
Connect ...