Kia Forte: Control Shaft Complete Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Shaft Complete Removal
| 1. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
|
| 3. |
Set shift lever to "N" position.
|
| 4. |
Separate the control cable from the control shaft after remove
the pin (A) and washer (B).
|
| 5. |
Remove the control shaft assembly after loosen the bolts.
|
Control Shaft Complete Description
Component location : Control shaft
assembly is mounted on the top of the manual transaxle
Function : Change the gear by shifting
a shift lever. ...
Control Shaft Complete Installation
1.
Install in the reverse order of removal.
•
...
See also:
Description
The charging system included a battery, an alternator with a built-in
regulator, and the charging indicator light and wire.
The Alternator has eight built-in diodes, each rectifying AC curre ...
ECM Terminal And Input/Output signal (M/T)
ECM Terminal Function
Connector [CNG-MA]
Pin No.
Description
Connected to
1
Ignition Coil (Cylinder #1) control output
Ignition Co ...
Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...
Copyright © www.kifomanual.com 2014-2024