1. |
Turn ignition switch OFF.
|
2. |
Disconnect the Solenoid valve connector.
|
3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
4. |
Check that the resistance is within the specification.
(Refer to Line Pressure Control Solenoid Valve - "Specifications")
|
Special Service Tools
Tool (Number and name)
Illustration
Use
09977-3R000
Disc & hub assembly bolt remover
Removal and installation of disc & hub assembly ...
Front Stabilizer Bar Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A ...
Removal
1.
Engine cover.
(Refer to Engine Mechanical System - "Engine cover")
2.
Air cleaner assembly and air duct.
(Refe ...