Kia Forte: 35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Description
Underdrive Brake(UD/B) Control Solenoid is attached to the valve body.
This variable force solenoid valve directly controls the hydraulic pressure
inside the Underdrive Brake(UD/B).
...
See also:
Components
[M/T]
1. Floor console assembly
2. Console upper cover
3. Console tray
4. Console armrest met
5. Rear console cover
6. Rear console airvent
7. Console du ...
Audio Unit Removal
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...
Intake Actuator Description
The intake actuator is located at the blower unit. It regulates the intake
door by the signal from the control unit. Pressing the intake selection switch
will shift between recirculation and ...
Copyright © www.kifomanual.com 2014-2025