Kia Forte: BJ Boot Components
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Components
| 1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot |
5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band |
9. TJ boot 10. Spider assembly 11. Snap ring 12. TJ case |
13. Circlip |
Dynamic Damper Installation
1.
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
...
BJ Boot Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to ...
See also:
Installation
•
Do not spill brake fluid on the vehicle: it may damage
the paint; if brake fluid does ...
IMS Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
Copyright © www.kifomanual.com 2014-2025