Kia Forte: Side Impact Sensor (SIS)

Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH).

Side Pressure Sensor is also called P-SIS because it detects pressure due to collision at its mounting location.

Side Impact Sensor is also called A-SIS because it detects acceleration.

SRSCM decides deployment of the airbag and the time of deployment through the collision signal of the SIS when the collision occurred.

Installation

   • Do not turn the ignition switch ON and do not contact the battery cable while replacin ...

Components

...

See also:

Oil Cooler Inspection
Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester. 2. ...

Water Temperature Control Assembly Removal and Installation
1. Remove the engine cover. 2. Drain the engine coolant. (Refer to Cooling System - "Coolant") 3. ...

35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection
1. Turn ignition switch OFF. 2. Disconnect the Solenoid valve connector. 3. Measure resistance between sensor ...