Kia Forte: Brake Booster Operating Test
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Brake System / Brake Booster / Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
| 1. |
Run the engine for one or two minutes, and then stop it. If the
pedal depresses fully the first time but gradually becomes higher when
depressed succeeding times, the booster is operating properly, if the
pedal height remains unchanged, the booster is inoperative.
|
| 2. |
With the engine stopped, step on the brake pedal several times.
Then step on the brake pedal and start the engine. If the pedal
moves downward slightly, the booster is in good condition. If there
is no change, the booster is inoperative.
|
| 3. |
With the engine running, step on the brake pedal and then stop
the engine.Hold the pedal depressed for 30 seconds. If the pedal height
does not change, the booster is in good condition, if the pedal rises,
the booster is inoperative.
If the above three tests are okay, the booster performance can
be determined as good.
Even if one of the above three tests is not okay, check the check
valve, vacuum hose and booster for malfunction.
|
Brake Booster
1. Brake booster
2. Master cylinder assembly
3. O-ring
...
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the battery (A) and ECM (B).
...
See also:
Seat Heater (Non-Air Ventilation) Circuit Diagram
※ The cushion heater and back cushion are connected with wiring. ...
Cruise control system
The cruise control system allows you to program the vehicle to maintain a constant
speed without depressing the accelerator pedal.
This system is designed to function above approximately 25 mph (40 ...
Multimedia Jack Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly&quo ...
Copyright © www.kifomanual.com 2014-2024