1. |
Remove the connector (A) from the wiper motor.
|
2. |
Attach the positive (+) lead from the battery to terminal 2 and
the negative (-) lead to terminal 5.
|
3. |
Check that the motor operates at low or high speed as below table.
|
Using the usb device
To use an external USB device, make sure the device is not connected when
starting up the vehicle. Connect the device after starting up.
If you start the engine when the USB device is connected ...
Water Temperature Control Assembly Removal and Installation
1.
Remove the engine cover.
2.
Drain the engine coolant.
(Refer to Cooling System - "Coolant")
3.
...
Components
1. Receiver
2. TPMS Sensor
3. TPMS Sensor
4. TPMS Sensor
5. TPMS Sensor
...