Kia Forte: Hood Latch Release Handle Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle Replacement

1.	After loosening the mounting screw, then remove the hood latch release handle (A).

2.

Install in the reverse order of removal.

•	Make sure the hood latch cable is connected properly.

•	Make sure the hood locks/unlocks and opens/closes properly.

Hood Latch Release Handle Component Location

1. Hood latch release handle ...

Hood Latch Component Location

1. Hood latch assembly ...

See also:

Removal
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to Body - & ...

Maintenance service
You should exercise the utmost care to prevent damage to your vehicle and injury to yourself whenever performing any maintenance or inspection procedures. Should you have any doubts concerning the i ...

Rear Body
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side outer p ...

Categories

Copyright © www.kifomanual.com 2014-2025