Kia Forte: Immobilizer Control Unit Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
|
| 3. |
Disconnect the connector of the immobilizer unit and then remove
the immobilizer unit (A) after loosening the bolt.
|
Replacement
Problems And Replacement Parts:
Problem
Part set
Scan tool required?
All keys have been lost
Blank key (4)
YES
Antenna coil unit does n ...
Immobilizer Control Unit Installation
1.
Install the immobilizer unit.
2.
Connector the immobilizer unit.
3.
Install the crash pad lower panel.
...
See also:
Starter Installation
1.
Install in the reverse order of removal.
Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...
Accelerator Position Sensor (APS) Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output volt ...
Measurement Method
Projected Dimensions
1.
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026