Kia Forte: Input Speed Sensor Installation - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Input Speed Sensor Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor Installation

1.
Installation is the reverse of removal.
  
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
Adding automatic transaxle fluid. (Refer to "Hydraulic system (Fluid)" in this group)
Input Speed Sensor Removal
1. Disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - &qu ...

Output Speed Sensor Description
The output speed sensor is a vital unit that measures the rate of rotation of the transaxle's turbine shaft and output shaft, and delivers the readings to the Transaxle Control Module(TCM ...

See also:

Speakers Installation
Front Speaker 1. Install the front speaker. 2. Install the front door trim. Rear Speaker 1. Install the ...

IMS Control Switch Inspection
1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat ...

35R Clutch Control Solenoid Valve(35R/C_VFS) Circuit Diagram
...

Copyright © www.kifomanual.com 2014-2025