Kia Forte: Inspection - Crankcase Emission Control System - Emission Control System - Kia Forte TD 2014-2018 Service ManualKia Forte: Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Emission Control System / Crankcase Emission Control System / Inspection

1.
After disconnecting the vapor hose from the PCV valve, remove the PCV valve.
2.
Reconnect the PCV valve to the vapor hose.
3.
Run the engine at idle, then put a finger over the open end of the PCV valve and make sure that intake manifold vacuum can be felt.
  
The plunger inside the PCV valve will move back and forth at vacuum.

4.
If the vacuum is not felt inspect PCV operation, if operating correctly clean or replace the vapor hose.
Schematic Diagram
...

Positive Crankcase Ventilation (PCV) Valve Operation Principle
...

See also:

Removal
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

Air Ventilation Seat Unit Installation
Cushion Blower 1. Install the cushion blower under the bottom of the seat. 2. Install the front seat aseembly. Back Blower ...

Measurement Method
Projected Dimensions 1. These are the dimensions measured when the measurement points are projected into the reference plane, and are the reference dimensions ...

Copyright www.kifomanual.com 2014-2025