Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Clutch System / Ignition Lock Switch / Installation

1.	Install in the reverse order of removal.

2.

Adjust the ignition lock switch.

(1)

In state of full stroke, adjust the gab by rotating the adjust nut (A) to satisfy the standard gap range.

Standard gap range :

3 ~ 4 mm (0.1181 ~ 0.1575 in.)

(2)

Tighten the nut (B) with the specified torque.

Tightening torque:

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Removal

1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the smart junction box. (Refer to Body Electri ...

Clutch Pedal

...

See also:

Ambient Temperature Sensor Description
The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, ...

Rear Seat Back Cover Component Location
(4Door, 2Door) 1. Rear seat back cover [LH] 2. Rear seat back cover [RH] (5Door) 1. Rear seat back assembly [LH] 2. Rear seat ...

Front Door Inside Handle Replacement
(4Door, 5Door, 2Door) 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. After loosenin ...

Categories

Copyright © www.kifomanual.com 2014-2026