Kia Forte: Measurement Method
| Projected Dimensions |
| 1. |
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions
used for body alterations.
|
| 2. |
If the length of the tracking gauge probes is adjustable, make
the measurement by lengthening one probe by the amount equivalent to
the difference in height of the two surfaces.
|
| Actual-Measurement Dimensions |
| 1. |
These dimensions indicate the actual linear distance between measurement
points, and are the reference dimensions for use if a tracking gauge
is used for measurement.
|
| 2. |
Measure by first adjusting both probes to the same length (A=A').
|
| Measurement Point |
| 1. |
Measurements should be taken at the hole center.
|
General
2DoorDynamic Damper Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refe ...
Electric Oil Pump Removal
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the Electric Oil Pump (EOP) connector (A).
3.
...
Positive Crankcase Ventilation (PCV) Valve Installation
1.
Installation is reverse of removal.
PCV Valve installation:
1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.45 ~ 2.17 lb-ft)
...