Kia Forte: Oil Pump Unit (OPU) Installation - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Oil Pump Unit (OPU) Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Oil Pump Unit (OPU) Installation

1.
Install in the reverse of removal.
Oil Pump Unit (OPU) Removal
1. Remove the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - “Crash Pad”) ...

Oil Pump Unit (OPU) Inspection
OPU Problem Inspection Procedure 1. TEST OPU GROUND CIRCUIT: Measure resistance between OPU and chassis ground using the backside of OPU harness connector ...

See also:

Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

Rear Wheel Speed Sensor Removal
1. Remove the rear wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Compression Pressure Inspection
   If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. ...

Copyright © www.kifomanual.com 2014-2024