1. |
Disconnect the negative (-) battery cable.
|
2. |
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
3. |
Remove the under cover (A).
|
4. |
Replace new gasket and the plug after draining the automatic transaxle
fluid by removing the drain plug.
(Refer to Hydraulic System - "Fluid")
|
5. |
Remove the air breather hose (A).
|
6. |
Remove the valve body cover (B).
|
7. |
Remove the plate and the detent spring (B) after removing the
bolt (A).
|
8. |
Remove the bolt (3ea) after disconnecting the solenoid valve connector
(B) and the oil temperature sensor connector (A).
|
9. |
Remove the valve body assembly (A).
|
10. |
Disconnect the input & output speed sensor connector (A).
|
11. |
Remove the input & output speed sensor (B) after removing the
bolts (2ea).
|
Telemetics Unit (TMU) Component
Connector Pin Specification
No.
Pin Name
Type
From
To
Description (Wiring
Spec.)
1
GND
DC Ground
TMU
Batt ...
Rolling code programming
To train a garage door opener (or other rolling code equipped devices) with the
rolling code feature, follow these instructions after completing the "Programming"
portion of this text. (A ...
Front Washer Motor Installation
1.
Install the washer reservoir.
Before installing the pump motor, check ...