Kia Forte: Rear Torsion Beam Axle Inspection - Rear Suspension System - Suspension System - Kia Forte TD 2014-2018 Service ManualKia Forte: Rear Torsion Beam Axle Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Suspension System / Rear Suspension System / Rear Torsion Beam Axle Inspection

1.
Check the hub for cracks and the splines for wear.
2.
Check the rear axle carrier for cracks.
Rear Torsion Beam Axle Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from f ...

Tires/Wheels
   • Using tires and wheel other than the recommended sizes could cause unusual handling ...

See also:

Replacement
Rear Brake Pads 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft ...

Checking the engine oil level
1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...

SRSCM Connector Terminal
Pin Function (Connector A) Pin Function (Connector B) 1 Ignition 1 Passenger side impact sensor (+) 2 - ...

Copyright © www.kifomanual.com 2014-2026