Kia Forte: Removal - Rear Drum Brake - Brake System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Brake System / Rear Drum Brake / Removal

  
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
Avoid breathing dust particles.
Never use an air hose or brush to clean brake assemblies.
1.
Release the parking brake.
2.
Remove the rear wheel & tire.

Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

3.
Remove the rear brake drum (A).

4.
Remove the upper return spring (A).

5.
Remove the lower return spring (A).

6.
Remove the shoe hold springs (A) and shoe hold pins (B) and then remove brake shoe (C). Make sure not to damage the dust cover on the wheel cylinder.

7.
Remove the parking brake cable (A) and then remove brake shoe (B).

8.
Disconnect brake tubes (A) from the wheel cylinder (B).

9.
Remove the bolts (C) and the wheel cylinder (B) from the backing plate (D).
Rear Drum Brake
Components 1. Shoe hold down pin 2. Shoe adjuster 3. Upper return spring 4. Adjusting lever 5. Shoe 6. Adjusting spring 7. Lower return spring 8. Shoe hold spri ...

Installation
   • Do not spill brake fluid on the vehicle: it may damage the paint; if brake fluid does ...

See also:

Inspection (With GDS)
1. Check BCM input/output specification of multifunction switch using the GDS. If the specification is abnormal, replace the lamp or wiper switch. ...

Teaching Procedures
1. Key Teaching Procedure Key teaching must be done after replacing a defective ECM or when providing additional keys to the vehicle owner. The procedure st ...

Telemetics Unit (TMU) Installation
1. Install the MTS unit after connecting the cable and connector. 2. Install the glove box housing. 3. Connect ...

Copyright © www.kifomanual.com 2014-2025