Kia Forte: Removal - Clutch Release Cylinder - Clutch System - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Clutch System / Clutch Release Cylinder / Removal

1.
Drain the brake fluid through the bleed plug (A).
  
•
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.

2.
Remove the clutch release cylinder assembly (C) after removing the tube (B) and bolts (A-2ea).

Tightening torque:
14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m,10.8 ~ 15.9 lb-ft)

Inspection
1. Check the clutch release cylinder for fluid leakage. 2. Check the clutch release cylinder boot for damage. ...

Installation
1. Install in the reverse order of removal.    Apply the specified grease to ...

See also:

Accelerator Position Sensor (APS) Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine ...

Components
Components (1) (4Door, 2Door) 1. Rear bumper cover 2. Rear bumper beam assembly 3. Rear bumper lower side bracket 4. Rear bumper side bracket [RH] 5. Rear bump ...

Room lamp
To turn the room lamp ON or OFF, push the switch. If your vehicle is not equipped with a map lamp, the room lamp will also turn on or off as follows. The room lamp comes on when a door is opene ...

Copyright � www.kifomanual.com 2014-2026