Kia Forte: Removal - Vacuum Pump - Brake System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Brake System / Vacuum Pump / Removal

1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the vacuum pump connector (A).

3.
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
4.
Disconnect the vacuum hose clip (A) and wiring harness clip (B) from the vacuum pump bracket.

5.
Remove the under covers (A).

Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

6.
Remove the intercooler inlet hose (A).

7.
Disconnect the vacuum hose (A).

8.
Loosen the vacuum pump bracket bolts (A) and then remove vacuum pump and bracket.

Tightening torque :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)

9.
Remove the bolts and then remove the vacuum pump (A) and lead wire assembly (B) from the bracket (C).

Tightening torque :
6.0 ~ 8.0 N.m (0.61 ~ 1.82 kgf.m, 4.4 ~ 5.9 lb-ft)

Vacuum Pump
Components 1. Vacuum pump 2. Bracket 3. Lead wire assembly ...

Inspection
1. Check the brake warning lamp in the IGN ON position.    Brake warnin ...

See also:

ETC (Electronic Throttle Control) System Description
The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cable, an Acc ...

Starter Removal
1. Disconnect the battery negative terminal. 2. Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical System - &quo ...

Compressor Removal
1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. ...

Copyright © www.kifomanual.com 2014-2025