Kia Forte: Replacement - Back-up Lamp Switch - Manual Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Manual Transaxle System / Back-up Lamp Switch / Replacement

1.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the back up lamp switch connector (A).

4.
Remove the back up lamp switch (A).

5.
Replace a new one and install the back up lamp switch.

Tightening torque:
39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

Inspection
1. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner") 2. Remove the battery and battery tray ...

Vehicle Speed Sensor
...

See also:

Side Impact Sensor (SIS)
Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH ...

System Block Diagram
...

Front Strut Assembly Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

Copyright © www.kifomanual.com 2014-2025