Kia Forte: Troubleshooting - Engine Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Troubleshooting

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Troubleshooting

Ignition System
Symptom
Suspect Area
Remedy
Engine will not start or is hard to
start (Cranks OK)
Ignition lock switch
Inspect ignition lock switch, or replace as required
Ignition coil
Inspect ignition coil, or replace as required
Spark plugs
Inspect spark plugs, or replace as required
Ignition wiring disconnected or broken
Repair wiring, or replace as required
Rough idle or stalls
Ignition wiring
Repair wiring, or replace as required
Ignition coil
Inspect ignition coil, or replace as required
Engine hesitates/poor acceleration
Spark plugs and spark plug cables
Inspect spark plugs / cable, or replace as required
Ignition wiring
Repair wiring, or replace as required
Poor mileage
Spark plugs and spark plug cables
Inspect spark plugs / cable, or replace as required

Charging System
Symptom
Suspect Area
Remedy
Charging warning indicator does not
 light with ignition switch "ON" and
 engine off.
Fuse blown
Check fuses
Light burned out
Replace light
Wiring connection loose
Tighten loose connection
Electronic voltage regulator
If light turns off, replace voltage regulator.
Charging warning indicator does not
go out with engine running. (Battery
requires frequent recharging)
Drive belt loose or worn
Adjust belt tension or replace belt
Battery cable loose, corroded or worn
Inspect cable connection, repair or replace cable
Electronic voltage regulator or alternator
If light turns off, replace voltage regulator or alternator
Wiring
Repair or replace wiring
Overcharge
Electronic voltage regulator
If light turns off, replace voltage regulator.
Voltage sensing wire
Repair or replace wiring
Discharge
Drive belt loose or worn
Adjust belt tension or replace belt
Wiring connection loose or short circuit
Inspect wiring connection, repair or replace wiring
Electronic voltage regulator or alternator
If light turns off, replace voltage regulator or alternator
Poor grounding
Inspect ground or repair
Worn battery
Replace battery

Starting System
Symptom
Suspect Area
Remedy
Engine will not crank
Battery charge low
Charge or replace battery
Battery cables loose, corroded or worn out
Repair or replace cables
Transaxle range switch
(Vehicle with automatic transaxle only)
Refer to AT group-automatic transaxle
Fuse blown
Replace fuse
Starter motor faulty
Replace
Ignition switch faulty
Replace
Engine cranks slowly
Battery charge low
Charge or replace battery
Battery cables loose, corroded or worn out
Repair or replace cables
Starter motor faulty
Replace
Starter keeps running
Starter motor faulty
Replace
Ignition switch
Replace
Starter spins but engine will not crank
Short in wiring
Repair or replace wiring
Pinion gear teeth broken or starter motor
Replace
Ring gear teeth broken
Replace fly wheel or torque converter

Special Service Tools
Tool Name / Number Illustration Description Alternator pulley remover wrench 09373-27000 Removal and installation of alternator pulley ...

Ignition System
...

See also:

Wipers & Washers
A : Wiper speed control (front) · HI – High wiper speed · LO – Low wiper speed · INT – Intermittent wipe · AUTO– Automatic control wipe · OFF – Off · MIST – Single wipe B : Interm ...

Blade inspection
Commercial hot waxes applied by automatic car washes have been known to make the windshield difficult to clean. Contamination of either the windshield or the wiper blades with foreign matter ca ...

Intake Air Temperature Sensor (IATS) Inspection
1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between the IATS termi ...

Copyright © www.kifomanual.com 2014-2024