Using Voice Recognition
Starting Voice Recognition
Shortly press the
key on the steering wheel. Say a command
If prompt feedback is in [ON], then the system will say “Please say a command after the beep (BEEP)”
Contact List Best Practices
1)Do not store single-name entries (e.g., “Bob”, “Mom”, “Kim”, etc.). Instead, always use full names (including first and last names) for all contacts (e.g., use “Jacob Stevenson” instead of “Dad”).
2)Do not use abbreviations (i.e., use “Lieutenant” instead of “Lt.” or “Sergeant” instead of “Sgt.”).
3)Do not use acronyms (i.e., use “County Finance Department” instead of “CFD”).
4)Do not use special characters (e.g., “@”, “hyphen -“, “asterisk *”, ampersand &”).
5)If a name is not recognized from the contact list, change it to a more descriptive name (e.g., use “Grandpa Joseph” instead of “Pa Joe”).
Skipping Prompt Messages
While prompt message is being stated
Shortly press the
key on the steering remote controller
The prompt message is immediately ended and the beep tone will sound. After the “beep”, say the voice command.
Re-starting Voice Recognition
While system waits for a command
Shortly press the
key on the steering remote controller
The command wait state is immediately ended and the beep ton will sound. After the “beep”, say the voice command.
Ending voice recognition
While Voice Recognition is operating
Press and hold the
key on the steering remote controller
Voice Recognition and Phone Contact Tips:
The Kia Voice Recognition System may have difficulty understanding some accents or uncommon names. When using Voice Recognition to place a call, speak in a moderate tone, with clear pronunciation
To maximize the use of Voice Recognition, consider these guidelines when storing contacts:
Illustration on using voice commands
Starting voice command.
Shortly pressing the
key (under 0.8 seconds):
Skipping Voice Recognition
Shortly pressing the
key (under 0.8 seconds):
while guidance message is being stated
Shortly pressing the
key (under 0.8 seconds)
End voice command.
Shortly pressing the
key (under 0.8 seconds):
Voice Command List
Common Commands:
These commands can be used in most operations. (However a few commands may not be available during certain operations)
FM/AM radio commands:
Commands available during FM, AM radio operation.
Satellite radio commands:
Commands that can be used while listening to Satellite Radio.
Audio CD commands:
Commands available during Audio CD operation.
MP3 CD / USB commands:
Commands available during USB and MP3 CD operation.
iPod® Commands:
Commands available during iPod® operation.
My Music Commands:
Commands available during My Music operation.
Bluetooth® Wireless Technology Audio Commands:
Commands available during Bluetooth® Wireless Technology audio streaming from mobile phone operation Command Operation
iPod® is a registered trademark of Apple Inc. iPod® mobile digital device sold separately. The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Kia is under license.
A Bluetooth® enabled cell phone is required to use Bluetooth® wireless technology. SiriusXM™ service requires a subscription, sold separately, after 3- month trial included with vehicle purchase. If you decide to continue your SiriusXM™ service at the end of the trial subscription, the plan you choose will automatically renew and bill at the current rates until you call SiriusXM™ at 1-866-635-2349 to cancel.
See our Customer Agreement for complete terms at www.siriusxm.com. Sirius satellite service is available only to those at least 18 and older in the 48 contiguous United States, D.C., and P.R. (with coverage limitations). SiriusXM™ Traffic available in select markets. See siriusxm.com/traffic for more information. Sirius, XM and all related marks and logos are trademarks of Sirius XM Radio Inc.
Special Service Tools
Tool Name / Number
Illustration
Description
Strut spring compressor
09546-26000
Compression of coli spring
...
Roof antenna Installation
1.
Install the roof antenna.
2.
Connect the roof antenna connectors.
3.
Install the rear roof trim.
...
Brake Booster Vacuum Pressure Sensor Inspection
1.
Check installation status of BBVPS and Vacuum hose or damage of
vacuum hose.
2.
Connect GDS to DLC (Data Link Cable).
...