Kia Forte: 35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Description
Underdrive Brake(UD/B) Control Solenoid is attached to the valve body.
This variable force solenoid valve directly controls the hydraulic pressure
inside the Underdrive Brake(UD/B).
...
See also:
BJ Boot Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to ...
Installation
1.
Install in the reverse order of removal.
If the oil seal on the transaxle case side is da ...
Components
Components (1)
(Rear Seat 5:5 Type)
[Rear Seat Back]
1. Rear seat headrest
2. Rear seat back webbing guide
3. Rear seat headrest guide
4. Rear seat back ...
Copyright © www.kifomanual.com 2014-2025